Caution: NTP Expert Mode should only be utilized by advanced users, as
incorrectly altering the NTP.conf file can cause NTP to stop working (if
NTP is configured as an input reference, SecureSync could lose syn-
chronization).
To access the NTP Expert Mode, navigate to MANAGEMENT > NTP Setup. The switch for
the NTP Expert Mode is in the panel NTP Services.
Caution: Any configurations made in NTP Expert Mode will be lost as soon
as NTP Expert Mode is disabled.
NTP utilizes the NTP.conf file for its configuration. Normally, configuration of this file is
indirectly performed by a user via the integrated configuration pages of the SecureSync
Web UI. However, it may be desired in certain circumstances to edit this file directly,
instead of using the web-based setup screens. When Expert Mode is enabled, the user has
direct access to the NTP.conf file.
Caution: Orolia Tech Support does not support the editing of the NTP con-
figuration files while in the Expert Mode. For additional information on edit-
ing the NTP.conf file, please refer to http://www.ntp.org/.
Note: IMPORTANT: If an undesirable change is made to the NTP.conf file
that affects the NTP operation, the NTP.conf file can be manually changed
back as long as the previous configuration was known.
The NTP.conf file can be reset back to the factory default values by either using the
procedure to restore all of the SecureSync factory default settings (see "Restoring
the Default NTP Configuration" on page100) or editing the file back to the original
configuration as shown in the factory default configuration below.
Caution: If changes are made to the NTP.conf file while in the Expert
mode, Expert mode should remain enabled from that point forward. Dis-
abling Expert mode after changes being made to this file may result in loss
of this configuration information.
2.15 Configure NTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
127
To Next Page
Loading...
Need help?
General
