Orolia SecureSync 2400 User Manual

receive position and timing information from the GNSS receiver in a consistent
format, and
use the WebUI (or CLI) to configure the GPSD service and view status information.
GPSD can only be configured to track the SecureSync internal u-blox receiver (GDPS does
not currently apply to the internal IMU or gyro for navigation purposes)..
To configure GPSD on the WebUI, navigate to MANAGEMENT > NETWORK > GPSD
Setup to access the GSPD Setup Screen
The GPSD Setup Screen is divided into three panels:
1.
The GPSD Service panel:
allows you to toggle the service ON or OFF
lists the Service Port
the Gear Icon in the GPSD Service panel allows you to change the Service
Port information. If your GPSD setup changes and needs to be reconfigured
within your SecureSync, this is where you can reset the service port.
2.
The Actions panel provides an option to restore the default configuration.
3.
The Receiver Status panel lists the information required by the GPSD service:
Device name
Mode, Time, Position, Track/Speed/Climb, Error Statistics, and Precision Stat-
istics
All satellites in view and the PRN, Elevation, Azimuth, Signal Strength, and
Usage for each satellite.
GPSD via CLI commands
The following CLI commands are used to control the behavior of GPSD via the
SecureSync CLI:
gpsdserviceportget – Displays the GPSD service port
gpsdserviceportset – Sets the GPSD service port
2.17 GPSD Setup
CHAPTER 2 • SecureSync 2400 User Manual Rev. 2
135

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English