Orolia SecureSync 2400 User Manual

4.
Select a setting and click Submit.
Available GNSS Receiver Dynamics Settings
The following Receiver Dynamics settings are available:
Land (Resurvey): [default]
When used with the Mobile Receiver Mode, the receiver is adjusted for typical
dynamic land-based applications.
When used with the Standard Receiver Mode, this setting also will automatically ini-
tiate a resurvey after SecureSync reboots, in order to account for a possible relo-
cation.
Sea: The receiver dynamics will be optimized for mobile motion patterns typical with
marine applications, resulting in greater timing accuracy, and avoiding premature
loss of synchronization.
Air: The receiver dynamics will be optimized for acceleration forces typically exper-
ienced in civil aviation applications.
Stationary (No Resurvey): In Standard Mode, the receiver is set to a non-dynamic
value for stationary applications.
There will be no automatic resurvey after a reboot. Should a unit be relocated, you
need to delete its position, thus initiating a new survey.
The following table illustrates the interdependence between Receiver Dynamics, Receiver
Mode (see "Selecting a GNSS Receiver Mode" on page209) and receiver type:
Table 3-2:
Receiver dynamics, ~modes, ~ dynamics, ~ types
Receiver Mode
Receiver Dynamics
Land
(Resurvey)
Sea Air
Stationary
(No Resurvey)
Single Satellite irrelevant irrelevant irrelevant irrelevant
Standard
Mobile (with u-blox receivers)
3.3 Managing References
CHAPTER 3 • SecureSync 2400 User Manual Rev. 2
213

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English