Relocating SecureSync
The Delete Position command may need to be used if a SecureSync system is physically
moved, and it did not self-initiate a new survey automatically. Note that neglecting to
delete the old position data and discover the new position data will cause SecureSync not
to go into synchronization state.
Sanitization
The Delete Position command must also be used when sanitizing a SecureSync unit
(ensuring that no trace of position data remains on the unit).
Deleting the GNSS position
To delete the GNSS position:
1.
Disconnect the GNSS antenna from the SecureSync unit (this is required only
when sanitizing the unit).
2.
Navigate to Interfaces > References: GNSS Reference.
3.
Click on the GEAR button next to the GNSS Reference (typically, there is only one
reference, numbered "0"). The GNSS0 window will open:
Locate the Delete Position box, check it, and click Submit.
4.
SecureSync will initiate a GNSS self survey.
Note: In Mobile Receiver Mode it is NOT possible to delete the position and
start the GNSS survey. This feature is only available in Standard Mode and
in Single Satellite Mode. In Single Satellite Mode a GNSS survey may take
up to 24 hours.
218
CHAPTER 3 • SecureSync 2400 User Manual Rev. 2
3.3 Managing References
To Next Page
Loading...
Need help?
General
