Orolia SecureSync 2400 User Manual

e.
Commands need to be typed in all lower-case letters.
f.
Where eth0 is the base network port and eth1 (and higher) are used with the
optional Gigabit Ethernet module for multiple network interfaces.
g.
User accounts with “user” group permissions can perform “get” commands but can-
not perform any “set” commands or change/reset passwords. Only user accounts
with “admin” group permissions can perform “set” commands or change/reset pass-
word. Refer to "Adding/Deleting/Changing User Accounts" on page252 for user
account setup information.
Command Description
clean Restores SecureSync configuration, logs, and stats to factory defaults and
reboots
cleanhalt Restores SecureSync configuration to factory defaults and halts
clearcfg Restores configuration to factory defaults and reboots
clearlogs Clears all logs
clearstats Clears all statistical data (NTP, and oscillator/disciplining)
dateget Displays current date (for example, 15 APR 2015)
dateset Used to set the current date
defcert Used to create a new Spectracom self-signed SSL certificate for HTTPS in case
of expiration of the original certificate
dhcp4get Displays whether DHCP is enabled
dhcp4set Used to enable or disable DHCP
dns4cfg Display the configured IPv4 primary and secondary DNS addresses
dns4get Displays the configured DNS servers
dns4set Used to configure the DNS servers
dhcp6get Displays whether DHCPv6 is enabled
dhcp6set Used to enable or disable DHCPv6
doyget Used to obtain the current Day of Year
doyset Used to set the current Day of Year
gpsdop Displays GNSS receiver positional accuracy estimates
gpsdserviceportget Displays the GPSD service port
gpsdserviceportset Sets the GPSD service port
SecureSync 2400 User Manual 515
APPENDIX

Orolia SecureSync 2400 Specifications

General

Brand	Orolia
Model	SecureSync 2400
Category	Recording Equipment
Language	English