Error Codes
D0C5/D0C6/D0C4/D0AP FAX UNIT 32 SM
Code Meaning Suggested Cause/Action
15-13 Receive Buffer Full
• Occurs only during manual reception.
Transmission cannot be received due to
insufficient buffer space. The buffer is being
used for mail send or Scan-to-Email.
15-14 Mail Header Format Error
• The mail header is not standard format. For
example, the Date line description is
incorrect.
15-15 Mail Divide Error
• The e-mail is not in standard format. There is
no boundary between parts of the e-mail,
including the header.
15-16 Mail Size Receive Error
• The mail cannot be received because it is too
large.
15-17 Receive Timeout
• May occur during manual receiving only
because the network is not operating
correctly.
15-18 Incomplete Mail Received
• Only one portion of the mail was received.
15-31 Final Destination for Transfer
Request Reception Format Error
• The format of the final destination for the
transfer request was incorrect.
15-39 Send/Delivery Destination Error The transmission cannot be delivered to the final
destination:
• Destination file format is incorrect.
• Could not create the destination for the file
transmission.
15-41 SMTP Receive Error
• Reception rejected because the transaction
exceeded the limit for the “Auth. E-mail RX”
setting.
15-42 Off Ramp Gateway Error
• The delivery destination address was
specified with Off Ramp Gateway OFF.
15-43 Address Format Error
• Format error in the address of the Off Ramp
Gateway.
15-44 Addresses Over
• The number of addresses for the Off Ramp
Gateway exceeded the limit of 30.
15-61 Attachment File Format Error
• The attached file is not TIFF format.
15-62 TIFF File Compatibility Error Could not receive transmission due to:
• Resolution error
• Image of resolution greater than 200 dpi
without extended memory.
• Resolution is not supported.
To Next Page
