SENSe Subsystem R&S FSL
1300.2519.12 6.172 E-11
SENSe Subsystem
The SENSe subsystem is organized in several subsystems. The commands of these subsystems
directly control device–specific settings, they do not refer to the signal characteristics of the
measurement signal.
The SENSe subsystem controls the essential parameters of the analyzer. In accordance with the SCPI
standard, the keyword "SENSe" is optional for this reason, which means that it is not necessary to
include the SENSe node in command sequences.
The following subsystems are included:
• "SENSe:AVERage Subsystem" on page 6.172
• "SENSe:BANDwidth Subsystem" on page 6.175
• "SENSe:CORRection Subsystem (Models with tracking generator)" on page 6.179
• "SENSe:DETector Subsystem" on page 6.186
• "SENSe:ESPectrum Subsystem" on page 6.187
• "SENSe:FREQuency Subsystem" on page 6.200
• "SENSe:LIST Subsystem" on page 6.205
• "SENSe:MPOWer Subsystem" on page 6.215
• "SENSe:POWer Subsystem" on page 6.220
• "SENSe:ROSCillator Subsystem" on page 6.228
• "SENSe:SWEep Subsystem" on page 6.229
SENSe:AVERage Subsystem
The SENSe:AVERage subsystem calculates the average of the acquired data. A new test result is
obtained from several successive measurements.
There are two types of average calculation: logarithmic and linear. In case of logarithmic average
calculation (denoted with VIDeo), the average value of the measured logarithmic power is calculated
and in case of linear average calculation, the linear power is averaged before the logarithm is applied.
Commands of the SENSe:AVERage Subsystem
– [SENSe<1|2>:]AVERage[:STATe<1...6>]
– [SENSe<1|2>:]AVERage:COUNt
– [SENSe<1|2>:]AVERage:COUNt:AUTO
– [SENSe<1|2>:]AVERage:TYPE
To Next Page
Loading...
