Procedure with Startdrive
1. Go online with the converter.
2. Select the command as follows from the project tree:
3. Click on the button in the dialog box as shown below:
You have saved your settings retentively in the EEPROM.
❒
Further information
For more information on saving the settings (RAM → EEPROM) on the SINAMICS G120 Smart
Access, see Section "Parameters" in the SINAMICS G120 Smart Access Operating Instructions.
Overview of the manuals (Page588)
6.6 Restoring the factory settings
When must you restore the factory settings?
Restore the converter to the factory settings in the following cases:
• You do not know the converter settings.
• The line voltage was interrupted during commissioning and you were not able to complete
commissioning.
Restoring the factory settings when the safety functions are enabled
If you are using the integrated safety functions of the converter, e.g. "Safe Torque O", you must
reset the safety functions separately from the remaining converter settings.
Commissioning
6.6Restoring the factory settings
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 125
To Next Page
Loading...
