Siemens SINAMICS G115D

10.Switch on the converter power supply again.
If the 󹪝rmware downgrade was successful, after several seconds the converter LED RDY turns
green.
The converter is reset to factory settings after 󹪝rmware downgrade.




5'<
9
11. Transfer the settings from your data backup to the converter.
Memory card → converter (Page355)
PG/PC → converter (Page359)
You have downgraded the converter 󹪝rmware to an older version and transferred the settings
to the converter.
❒
10.6.4 Correcting an unsuccessful 󹪝rmware upgrade or downgrade
Precondition
The converter signals an unsuccessful 󹪝rmware upgrade or downgrade with a quickly 󹪞ashing
LED RDY and a lit-up LED BF (or AS-i FLT).
%)RU$6L)/7
5'<
9
Correcting a failed upgrade or downgrade
You can check the following to correct an unsuccessful 󹪝rmware upgrade or downgrade:
• Have you inserted the card properly?
• Does the card contain the correct 󹪝rmware?
Repeat the 󹪝rmware upgrade or downgrade procedure.
Corrective maintenance
10.6Firmware upgrade and downgrade
SINAMICS G115D Wall Mounted distributed drive
408 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA