Siemens SINAMICS G115D

6.3.2 Collecting motor data
G115D converter with SIMOGEAR geared motor
If you use a G115D converter with SIMOGEAR geared motor, you do not need to input speci󹪝c
motor data since all necessary motor data is pre-con󹪝gured in the factory.
For more information about the detailed motor data, refer to the following section:
Rating plate for geared motors with SINAMICS G115D Motor Mounted (Page442)
G115D wall-mounted converter
For a G115D wall-mounted converter, if you use a SIMOGEAR geared motor for SINAMICS
G115D, you only need to specify the article number of the motor in the commissioning tool
(Startdrive or SINAMICS G120 Smart Access); otherwise, you must enter the data shown on the
motor rating plate.
Data for a SIMOGEAR geared motor
Rating plate for geared motors with SINAMICS G115D Wall Mounted (Page443)
Pay attention to the connection of the motor (star connection [Y] or delta connection [Δ] ).
Note the appropriate motor data for connecting.
Commissioning
6.3Preparing for commissioning
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 109