Siemens SINAMICS G115D

7.3.2 Digital Inputs
Changing the function of the digital inputs
2
5
4
1 3
;
',
',
U
2
5
4
1 3
;
',
',
U
U
2
5
4
1 3
;
',2

',2

U
U
U
%,S[[[[
1)
Parameterized as digital inputs
Interconnect the status parameter of the digital in‐
put with a binector input of your choice.
Interconnecting signals in the converter
(Page581)
Binector inputs are marked with "BI" in the parame‐
ter list of the List Manual.
Binector inputs (BI) of the converter
BI Signi󹪝cance BI Signi󹪝cance
p0810 Command data set selection CDS bit 0 p1036 Motorized potentiometer, setpoint, lower
p0840 ON/OFF1 p1055 Jog bit 0
p0844 OFF2 p1056 Jog bit 1
p0848 OFF3 p1113 Setpoint inversion
p0852 Enable operation p1201 Flying restart enable signal source
p0855 Unconditionally release holding brake p2103 1st acknowledge faults
p0856 Enable speed controller p2106 External fault 1
p0858 Unconditionally close holding brake p2112 External alarm 1
p1020 Fixed speed setpoint selection bit 0 p2200 Technology controller enable
p1021 Fixed speed setpoint selection bit 1 p3330 Two-wire/three-wire control, control com‐
mand 1
p1022 Fixed speed setpoint selection bit 2 p3331 Two-wire/three-wire control, control com‐
mand 2
p1023 Fixed speed setpoint selection bit 3 p3332 Two-wire/three-wire control, control com‐
mand 3
p1035 Motorized potentiometer, setpoint, raise  
A complete list of the binector inputs is provided in the List Manual.
Example
2
5
4
1 3
;
722.2
p0840
U
',
In order to switch on the motor with digital input DI 2,
you have to connect the status parameter of DI2 to
p0840: Set p0840=722.2.
Advanced commissioning
7.3Adapt the default settings of the inputs and outputs
SINAMICS G115D Wall Mounted distributed drive
134 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA