Siemens SINAMICS G115D

• Device replacement without removable data storage medium: the replaced converter
obtains the device name from the IO controller – not from its memory card or programming
device
• Shared Device for converters that support PROFIsafe
The converter as Ethernet node
6,1$0,&6*'
:DOO0RXQWHG
6,1$0,&6*'
0RWRU0RXQWHG
3&
6,1$0,&6*
6,1$0,&6*&
6,1$0,&6*;
(WKHUQHW
Further information on PROFINET
Further information on PROFINET can be found on the Internet:
•
PROFINET system description (https://support.industry.siemens.com/cs/ww/en/view/
19292127)
• PROFINET - the Ethernet standard for automation (http://w3.siemens.com/mcms/
automation/en/industrial-communications/pro󹪝net/Pages/Default.aspx)
Further information on the operation as Ethernet nodes can be found in the Function Manual
"Fieldbuses".
Overview of the manuals (Page588)
5.13.3 Protocols used
The converter supports the protocols listed in the following tables. The address parameters, the
relevant communication layer as well as the communication role and the communication
direction are speci󹪝ed for each protocol.
You require this information to set the appropriate safety measures to protect the automation
system, e.g. in the 󹪝rewall.
Wiring
5.13Connecting to PROFINET and Ethernet
SINAMICS G115D Wall Mounted distributed drive
90 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA