Procedure
1. Go online.
2. Proceed as follows to transfer converter settings to the memory card.
3. Wait until Startdrive reports that data backup has been completed.
You have backed up the converter settings to the memory card.
❒
Transferring using SINAMICS G120 Smart Access
You can use the SINAMICS G120 Smart Access to transfer settings. For more information on the
transferring process, see Section "Backup and restore" in the SINAMICS G120 Smart Access
Operating Instructions.
Overview of the manuals (Page588)
8.1.3 Memory card → converter
You can transfer parameter settings from a memory card to the converter by the following
methods:
• Automatic transfer
• Transfer with Startdrive
• Transfer with SINAMICS G120 Smart Access
Automatic transfer
Precondition
The converter power supply has been switched o.
Procedure
1. Insert the memory card into the memory card slot.
2. Switch on the converter power supply.
Data backup and series commissioning
8.1Transferring settings using a memory card
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 355
To Next Page
Loading...
