Siemens SINAMICS G115D

If you have not only selected motor data identi󹪝cation with the motor stationary, but also
rotating measurement with self-optimization of the speed control, you must switch on the
motor again as described above and wait for the optimization run to 󹪝nish.
Quick commissioning has been completed once the motor data identi󹪝cation has been
successfully completed.
6.4.3 Quick commissioning with the SINAMICS G120 Smart Access
You can access the SINAMICS G120 Web pages from a PC or a mobile device that connects to the
SINAMICS G120 Smart Access. The Web pages allow you to con󹪝gure a comprehensive range of
settings to meet the speci󹪝c requirements of the G115D converters. You can perform the
following three setups:
• Quick setup
• Application setup
• Safety setup
Further information
For more information on accessing the SINAMICS G120 Web pages and carrying out quick
commissioning, see the SINAMICS G120 Smart Access Operating Instructions.
Overview of the manuals (Page588)
Commissioning
6.4Quick commissioning
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 123