Siemens SINAMICS G115D

2XWSXWIUHTXHQF\>+]@
3HUPLVVLEOH
RXWSXWFXUUHQW
>@
6SRUDGLFVKRUWWLPHGXW\
6KRUWWLPHGXW\
&RQWLQXRXVGXW\













• Continuous operation (green area in the 󹪝gure)
Operating state that is permissible for the complete operating time.
• Short-time operation (yellow area in the 󹪝gure)
Operating state that is permissible for less than 2% of the total operating time.
• Sporadic short-time operation (red area in the 󹪝gure)
Operating state that is permissible in very short and seldom operating conditions for less
than 1% of the total operating time.
11.3 Data regarding the power loss in partial load operation
Note
This product is covered by the regulation (EU) 2019/1781; however, according to Article 2, (3)
a), the SINAMICS G115D Motor Mounted drive is a motor-integrated drive and therefore no
e󹪟ciency requirements apply. According to Article 2, (2) b), the geared motor for the SINAMICS
G115D Motor Mounted drive is a motor with an integrated variable speed drive and therefore no
e󹪟ciency requirements apply.
You can 󹪝nd data regarding power loss in partial load operation in the Internet:
Partial load operation (https://support.industry.siemens.com/cs/ww/en/view/94059311)
11.4 Electromagnetic compatibility of the converter
EMC (electromagnetic compatibility) means that the devices function satisfactorily without
interfering with other devices and without being disrupted by other devices. EMC applies when
the emitted interference (emission level) and the interference immunity are matched with each
other.
The product standard IEC/EN 61800-3 describes the EMC requirements placed on "Variable-
speed drive systems".
Technical data
11.4Electromagnetic compatibility of the converter
SINAMICS G115D Wall Mounted distributed drive
422 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA