Siemens SINAMICS G115D

Changing the number of command data sets
1. Set p0010=15.
2. The number of command data sets is con󹪝gured with p0170.
3. Set p0010=0.
You have changed the number of command data sets.
❒
Copying command data sets
1. Set p0809[0] to the number of the command data set whose settings you wish to copy
(source).
2. Set p0809[1] to the number of the command data set in which you wish to copy the settings.
3. Set p0809[2]=1 to start the copying.
4. The converter sets p0809[2] = 0 after the copying 󹪝nishes.
You have copied the settings of a command data set into another command data set.
❒
Example
&RQWURO
IXQFWLRQV
&RQYHUWHU
FRQWURO
&RQYHUWHU
FRQWURO
$FNQRZOHGJH
6HOHFWFRPPDQGGDWDVHW
&RPPDQGGDWDVHW
3DUDPHWHULQGH[>@
&RPPDQGGDWDVHW
3DUDPHWHULQGH[>@
-RJ
-RJ
$FNQRZOHGJH
&RQWUROE\3/&
023ORZHU
212))
U
S>@
U
S>@
U
S>@
U
S>@
U
S>@
U
S>@
U
S>@
U
S
&'6
&'6
;
;
















3='
3='
3='
3='
3='
3='
3='
3='
As in the example above, you obtain the interconnection if you con󹪝gured the interfaces of
the converter accordingly.
Advanced commissioning
7.10Switching over the drive control (command data set)
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 223