Siemens SINAMICS G115D - Data backup and series commissioning

If you use other SD or MMC memory cards, then you must format the memory card as
follows:
• MMC: Format FAT16
– Insert the card into your PC's card reader.
– Command to format the card:
formatx:/fs:fat (x: Drive code of the memory card on your PC)
• SD: Format FAT16 or FAT 32
– Insert the card into your PC's card reader.
– Command to format the card:
formatx:/fs:fat or formatx:/fs:fat32 (x: Drive code of the memory card on your PC.)
Functional restrictions with memory cards from other manufacturers
The following functions are either not possible – or only with some restrictions – when using
memory cards from other manufacturers:
• Licensing functions is only possible using the recommended memory cards.
• Know-how protection is only possible with one of the recommended memory cards.
• In certain circumstances, memory cards from other manufacturers do not support writing or
reading data from/to the converter.
Advanced commissioning
7.31Activating licensed functions
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 349