Siemens SINAMICS G115D

Function description
Alarms have the following properties:
• Incoming alarms have no direct in󹪞uence on the converter.
• Alarms disappear when the cause is eliminated.
• Alarms do not have to be acknowledged.
• Alarms are displayed as follows:
– Display via bit7 in status word1 (r0052)
– Display in Startdrive
– Display in the SINAMICS G120 Smart Access
The alarm code or alarm value describes the cause of the alarm.
Alarm bu󹪜er
ROG
QHZ
$ODUPFRGH$ODUPYDOXH$ODUPWLPHUHFHLYHG$ODUPWLPHUHPRYHG
'D\V'D\V
U>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
>@
U>@U>@U>@U>@U>@U>@
,IORDWPVPV
The converter saves incoming alarms in the alarm bu󹪜er. An alarm includes an alarm code,
an alarm value, and two alarm times:
• Alarm code: r2122
• Alarm value: r2124 in 󹪝xed-point format "I32", r2134 in 󹪞oating-point format "Float"
• Alarm time received = r2145 + r2123
• Alarm time removed = r2146 + r2125
The converter takes its internal time calculation to save the alarm times.
System runtime (Page373)
Up to 8 alarms can be saved in the alarm bu󹪜er.
In the alarm bu󹪜er, the warnings are sorted according to "Warning time received". If
the alarm bu󹪜er is completely 󹪝lled and an additional alarm occurs, then the converter
overwrites the values with Index[7].
Alarm history
Alarms, faults and system messages
9.4Alarms, alarm bu󹪜er, and alarm history
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 375