Siemens SINAMICS G115D

Parameters
Parameters of the alarm bu󹪜er and the alarm history
Parameter Description Setting
p2111 Alarm counter Number of alarms that have occurred after the last
reset.
When setting p2111 = 0, the following is initiated:
• All of the alarms that have been removed from
the alarm bu󹪜er [0...7] are transferred into the
alarm history [8...63].
• The alarm bu󹪜er [0...7] is deleted.
Factory setting: 0
r2122[0…63] Alarm code Displays the numbers of the alarms that have oc‐
curred.
r2123[0…63] Alarm time received in milli‐
seconds
Displays the time in milliseconds when the alarm
occurred.
r2124[0…63] Alarm value Displays additional information about the alarm.
r2125[0…63] Alarm time removed in milli‐
seconds
Displays the time in milliseconds when the alarm
was removed.
r2132 CO: Actual alarm code Displays the code of the alarm that last occurred.
r2134[0…63] Alarm value for 󹪞oat values Displays additional information about the alarm
that occurred for 󹪞oat values.
r2145[0…63] Alarm time received in days Displays the time in days when the alarm occurred.
r2146[0…63] Alarm time removed in days Displays the time in days when the alarm was re‐
moved.
Extended settings for alarms
Parameter Description Setting
You can change up to 20 di󹪜erent alarms into faults or suppress alarms:
p2118[0…19] Changing message type, mes‐
sage number
Selects faults or alarms for which the message type
should be changed.
Factory setting: 0
p2119[0…19] Changing message type, type Sets the message type for the selected fault or
alarm.
1: Fault
2: Alarm
3: No message
Factory setting: 1
For more information about this function, see function diagram 8075 and parameter
description in the List Manual.
Alarms, faults and system messages
9.4Alarms, alarm bu󹪜er, and alarm history
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 377