Siemens SINAMICS G115D

Parameters
Parameters of the fault bu󹪜er and the fault history
Parameter Description Setting
r0945[0…63] Fault code Displays the numbers of the faults that have occur‐
red.
r0948[0…63] Fault time received in millisec‐
onds
Displays the system runtime in milliseconds when
the fault occurred.
r0949[0…63] Fault value Displays additional information about the fault that
occurred (as integer number).
p0952 Fault cases counter Number of fault cases that have occurred since the
last acknowledgment.
With p0952 = 0, you delete the fault bu󹪜er and the
fault history.
Factory setting: 0
r2109[0…63] Fault time removed in milli‐
seconds
Displays the system runtime in milliseconds when
the fault was removed.
r2130[0…63] Fault time received in days Displays the system runtime in days when the fault
occurred.
r2131 Actual fault code Displays the code of the oldest active fault.
r2133[0…63] Fault value for 󹪞oat values Displays additional information about the fault that
occurred for 󹪞oat values.
r2136[0…63] Fault time removed in days Displays the system runtime in days when the fault
was removed.
Extended settings for faults
Parameter Description Setting
You can change up to 20 di󹪜erent faults into alarms, suppress faults, modify the fault response, or modify
the acknowledgment mode:
p2100[0…19] Changing fault response,
fault number
Selects the faults for which the fault response
should be changed.
Factory setting: 0
p2101[0…19] Changing the fault reaction,
reaction
Sets the fault reaction for the selected fault.
0: NONE
1: OFF1
2: OFF2
3: OFF3
5: STOP2
6: Internal armature short-circuit / DC braking
Factory setting: 0
p2118[0…19] Changing message type, mes‐
sage number
Selects faults or alarms for which the message type
should be changed.
Factory setting: 0
Alarms, faults and system messages
9.5Faults, fault bu󹪜er and fault history
SINAMICS G115D Wall Mounted distributed drive
380 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA