Siemens SINAMICS G115D

Function description
The following procedure applies to both the G115D motor-mounted converter and the G115D
wall-mounted converter.
Procedure
1. Switch o󹪜 the line voltage to the converter and (if installed) the external 24 V power supply
or the voltage for the digital outputs of the converter.
2. Wait until all LEDs on the converter are dark.


/('2))

9
3. Insert the memory card with the matching 󹪝rmware into the converter slot until it latches into
place.

9
4. Switch on the power supply of the converter again.
5. The converter transfers the 󹪝rmware from the memory card into its memory.
The transfer takes approximately 5 to10 minutes.
While data is being transferred, the LED RDY on the converter stays red. The LED BF or AS-i/FLT
󹪞ashes orange with a variable frequency.

%)RU$6L)/7
5'<


PLQ
9
Corrective maintenance
10.6Firmware upgrade and downgrade
SINAMICS G115D Wall Mounted distributed drive
404 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA