Siemens SINAMICS G115D

Paint system Description
Corrosiveness category C3 for medium environmental stress
2‑component epoxy zinc phosphate base
coat,
2‑component polyurethane top coat
• Indoor and outdoor installation
• Production areas with high humidity and some air
contamination, e.g.food production areas, dairies,
breweries and laundries
• Urban and industrial atmospheres, moderate contam‐
ination from sulfur dioxide, coastal areas with low salt
levels
• Resistance to greases, mineral oils, aliphatic solvents,
sulfuric acid(10%), caustic soda(10%)
Paint system Description
Corrosiveness category C4 for high environmental stress
2‑component epoxy zinc phosphate base
coat,
2‑component polyurethane top coat
• Indoor and outdoor installation
• Chemical plants, swimming pools, wastewater treat‐
ment plants, electroplating shops, and boathouses
above seawater
• Industrial areas and coastal areas with moderate salt
levels
• Resistance to greases, mineral oils, aliphatic solvents,
sulfuric acid(10%), caustic soda(10%)
Paint system Description
Corrosiveness category C5 for very high environmental stress
2‑component epoxy zinc phosphate base
coat,
2‑component polyurethane intermediate
coat,
2‑component polyurethane top coat
• Indoor and outdoor installation
• Buildings and areas with almost constant condensa‐
tion and high levels are contamination, e.g.malt fac‐
tories and aseptic areas
• Industrial areas with high humidity and aggressive at‐
mosphere, coastal areas and o󹪜shore environments
with high salt levels
• Resistance to greases, mineral oils, aliphatic solvents,
sulfuric acid(10%), caustic soda(20%)
In case of corrosiveness category C1, overpainting with a 1‑component hydrosystem after
prior rubbing down is possible.
In case of corrosiveness categories C2toC5, overpainting with 2‑component polyurethane
paint, 2‑component epoxide paint and 2‑component acrylic paint after prior rubbing down is
possible.
Additional information on the SIMOGEAR geared motor
12.1General information geared motor with SINAMICS G115D Motor Mounted / Wall Mounted
SINAMICS G115D Wall Mounted distributed drive
430 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA