Siemens SITRANS F - Page 144

Setup
3.4 Inputs and outputs
FST030
142 Function Manual, 04/2017, A5E35693328-AA
3.4.5.7.9 Pulse width units
Description
Units of pulse duration value used to configure Ch3 pulse width.
Setting
s (seconds); ms (milliseconds); μs (micro seconds)
Default
s (seconds)
Related
Path
Setup → Inputs and outputs → Channel 3 - input/output → Pulse output → Pulse width units
3.4.5.7.10 Pulse width
Description
Pulse duration.
Setting
0.00 s to 4.00 s
Default
0.10 s
Related
Path Setup → Inputs and outputs → Channel 3 - input/output → Pulse output → Pulse width
3.4.5.7.11 Polarity
Description
Logical polarity of pulse output.
Setting
Active high level; Active low level
Default
Active high level
Related
Path
Setup → Inputs and outputs → Channel 3 - input/output → Pulse output → Polarity
3.4.5.7.12 Fail-safe behaviour
Description
Pulse output reaction in case of a fault.
Setting
Last valid value; Hold; Current value; Fail-safe value
Default
Last valid value