Siemens SITRANS F - Auxiliary Temperature; Standardizing Factor; Liquid Identifier

Maintenance and diagnostics
4.8 Simulation
FST030
300 Function Manual, 04/2017, A5E35693328-AA
4.8.2.18
Auxiliary temperature
4.8.2.18.1 Simulation value
Description
Auxiliary temperature - Enter the value used to simulate the process value.
Setting
-273.0 °C (-459.399994 °F) to +400.0 °C (752.0 °F)
Default
20.0 °C (68 °F)
Related
Only if Auxiliary temperature is marked in
Enable simulation
, then the setting of this
parameter
will be relevant.
The range and default setting are dependent on the selected
Unit
.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Auxiliary tem-
perature → Simulation value
4.8.2.19
Standardizing factor
4.8.2.19.1 Simulation value
Description
Standardizing factor
Setting
0.0 to 1000000.0
Default
0.0
Related
Only if Standardizing factor is marked in
Enable simulation
, then the setting of this parameter
will be relevant.
The range and default setting are dependent on the selected
Unit
.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Standardizing
factor → Simulation value
4.8.2.20
Liquid identifier
4.8.2.20.1 Simulation value
Description
Liquid identifier