Siemens SITRANS F - Kinematic Viscosity; Pressure

Maintenance and diagnostics
4.8 Simulation
FST030
296 Function Manual, 04/2017, A5E35693328-AA
Related
Only if Density is marked in
Enable simulation
, then the setting of this parameter will be
relevant.
The range and default setting are dependent on the selected
Unit.
Path Maintenance and diagnostics → Simulation → Simulation process values → Density → Simu-
lation value
4.8.2.9
Kinematic viscosity
4.8.2.9.1 Simulation value
Description
Set the Kinematic viscosity value to be simulated.
Setting The range is shown as minimum and maximum values in the HMI.
Default
0.000001 m
2
/s
Related
Only if Kinematic viscosity is marked in
Enable simulation
, then the setting of this parameter
will be relevant.
The range and default setting are dependent on the selected
Unit.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Kinematic vis-
cosity → Simulation value
4.8.2.10
Pressure
4.8.2.10.1 Simulation value
Description
Set the Pressure value to be simulated.
Setting
0.0 Pa to 100000000.0 Pa
Default
700000.0 Pa
Related
Only if Pressure is marked in
Enable simulation
, then the setting of this parameter will be
relevant.
The range and default setting are dependent on the selected
Unit.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Pressure →
Simulation value