Siemens SITRANS F - Totalizer Events; Device Events; Simulation Events (1)

Maintenance and diagnostics
4.2 Diagnostic events
FST030
248 Function Manual, 04/2017, A5E35693328-AA
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Process events (4)
4.2.7.7
Totalizer events
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
136 Totalizer 1 above alarm limit; 137 Totalizer 1 above warning limit; 138 Totalizer 1 be-
low warning limit; 139 Totalizer 1 below alarm limit; 140 Totalizer 2 above alarm limit; 141
Totalizer 2 above warning limit; 142 Totalizer 2 below warning limit; 143 Totalizer 2 below
alarm limit; 144 Totalizer 3 above alarm limit; 145 Totalizer 3 above warning limit; 146
Totalizer 3 below warning limit; 147 Totalizer 3 below alarm limit
Default
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Totalizer events
4.2.7.8
Device events
Description
If one of the selected events appears this affects the status icon, the related status output
and the alarm on the communication interface.
Setting
148 Transm. temp. above alarm limit; 149 Transm. temp. below alarm limit; 150 Sensor
signal disruption; 159 Internal error in transmitter
Default
Related
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Device events
4.2.7.9
Simulation events (1)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.