Siemens SITRANS F - Channel 4 - Relay; Calibration Picture

Maintenance and diagnostics
4.4 Diagnostics
FST030
Function Manual, 04/2017, A5E35693328-AA
273
Related
This parameter is only available if
Operation mode
is set to Pulse output.
Path Maintenance and diagnostics → Diagnostics → Inputs and outputs → Channel 4 - in-
put/output → Pulse counter
4.4.3.5.5 Reset pulse counter
Description
The pulse counter can be reset.
Setting Cancel; OK
Default
Cancel
Related
This parameter is only available if
Operation mode
is set to Pulse output.
Path
Maintenance and diagnostics → Diagnostics → Inputs and outputs → Channel 4 - in-
put/output → Reset pulse counter
4.4.3.6
Channel 4 - relay
4.4.3.6.1 Status output signal (read only)
Description
The channel value can be viewed in this parameter.
Related
This parameter is only available if
Operation mode
is set to On.
Path
Maintenance and diagnostics → Diagnostics → Inputs and outputs → Channel 4 - relay →
Status output signal
4.4.3.7
Calibration picture
Description
Calibration picture
Setting
Default
mA