Siemens SITRANS F - Standard Density; Units

To Next Page

To Previous Page

Setup

3.2 Process values

FST030

Function Manual, 04/2017, A5E35693328-AA

3.2.10.3.4 Lower alarm limit

Description

Falling below this limit causes an alarm.

Setting

-272.77 to +400.00 °C

Default

-270.00 °C

Path

Setup → Process values → Medium temperature → Alarm and warning limits → Lower alarm

limit

3.2.10.3.5 Hysteresis

Description

Sets the hysteresis for alarm and warning limits. The hysteresis is the distance between the

limits for activation and deactivation of an alarm/warning.

Setting

0.00 °C to +200.00 °C

Default

0.00 °C

Path

Setup → Process values → Medium temperature → Alarm and warning limits → Hysteresis

3.2.11

Standard density

3.2.11.1

Units

Description

Select units for displayed standard density. Units are not applied at communication interface.

Setting

μg/l (micrograms per liter); μg/m³ (micrograms per cubic meter); mg/l (milligrams per liter);

g/ml (grams per milliliter); g/cm³ (grams per cubic centimeters); g/l (grams per liter); kg/l

(kilograms per liter); kg/m³ (kilograms per cubic meter); lb/in³ (pounds per cubic inch);

lb/gal (pounds per US gallon); lb/ft³ (pounds per cubic foot); STon/yd³ (1 STon = 2000 lb);

custom unit (see Custom density unit string / factor)

Default

kg/m³ (kilograms per cubic meter)

Other manuals for Siemens SITRANS F