Siemens SITRANS F - Density; Units; Custom Units; Custom Conversion Factor

Setup
3.2 Process values
FST030
62 Function Manual, 04/2017, A5E35693328-AA
Related
Path
Setup → Process values → LiquIdent → Pressure slope factor
3.2.7
Density
3.2.7.1
Units
Description
Displays units for displayed density. Units are not applied at communication interface.
Read only.
Setting
μg/l (micrograms per liter); μg/m³ (micrograms per cubic meter); mg/l (milligrams per liter);
g/ml (grams per milliliter); g/cm³ (grams per cubic centimeters); g/l (grams per liter); kg/l
(kilograms per liter); kg/m³ (kilograms per cubic meter); lb/in³ (pounds per cubic inch);
lb/gal (pounds per US gallon); lb/ft³ (pounds per cubic foot); STon/yd³ (1 STon = 2000 lb);
custom units (see Custom units / Custom conversion factor)
Default
kg/m³ (kilograms per cubic meter)
Related
Path
Setup → Process values → Density → Units
3.2.7.2
Custom units
Description
User specific text string to define custom unit values. The custom unit can then be selected
in the density units.
Setting
Default
Related
Path
Setup → Process values → Density → Custom units
3.2.7.3
Custom conversion factor
Description
Conversion factor for custom Density values based on SI density units kg/m
3
.
Setting
Default
1.0