Siemens SITRANS F - Simulate Alarms; Simulation Mode; Alarms

Maintenance and diagnostics
4.8 Simulation
FST030
Function Manual, 04/2017, A5E35693328-AA
301
Setting
0 to 255
Default
0
Related
Only if Standardizing factor is marked in
Enable simulation
, then the setting of this parameter
will be relevant.
The range and default setting are dependent on the selected
Unit
.
Path
Maintenance and diagnostics → Simulation → Simulation process values → Liquid identifier
→ Simulation value
4.8.3
Simulate alarms
4.8.3.1
Simulation mode
Description
The alarm simulation mode can be configured in this parameter.
Setting
Off; Simulate alarm (ID number); Simulate alarm class
Default
Off
Related
If
Simulation mode
is set to Simulate alarm (ID number),
Alarms
and its subcategories will be
available.
If
Simulation mode
is set to Simulate alarm class,
Alarm class
will be available.
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Simulation mode
4.8.3.2
Alarms
4.8.3.2.1 Sensor alarms (1)
Description
The simulation of single and multiple
Sensor alarms (1)
can be configured.
Setting
Various sensor alarms can be selected
Default
None selected