Siemens SITRANS F - Alarm Class

Maintenance and diagnostics
4.8 Simulation
FST030
304 Function Manual, 04/2017, A5E35693328-AA
Related
This parameter is only available if
Simulation mode
is set to Simulate alarm (ID number).
Path Maintenance and diagnostics → Simulation → Simulation alarms → Alarms → Totalizer
alarms
4.8.3.2.8 Channel 1 alarms
Description
The simulation of single and multiple
Channel 1 alarms
can be configured.
Setting CH1 loop current too low; CH1 loop current too high; CH1 current output deviation; Func-
tional safety event; CH1 cable break
Default
None selected
Related
This parameter is only available if
Simulation mode
is set to Simulate alarm (ID number).
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarms → Channel 1
alarms
4.8.3.2.9 Input/output alarms
Description
The simulation of single and multiple
Input/output alarms
can be configured.
Setting
Various input/output alarms can be selected
Default
None selected
Related
This parameter is only available if
Simulation mode
is set to Simulate alarm (ID number).
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarms → Input/output
alarms
4.8.3.3
Alarm class
Description
The Siemens standard alarm class to be simulated can be configured. The alarm status is
activated on all outputs.
Setting
Maintenance alarm; Function check; Process value alarm; Process value warning; Mainte-
nance warning; Maintenance required
Default
None selected