Siemens SITRANS F - Device Alarms; Device Alarms - Settings; Channel 1 Alarms; Input;Output Alarms (1)

Setup
3.4 Inputs and outputs
FST030
162 Function Manual, 04/2017, A5E35693328-AA
3.4.6.10
Device alarms
Description
Device alarms - If one of the selected events appears this affects the status icon, the related
status output, and the alarm on the communication interface.
3.4.6.11
Device alarms - settings
Setting
148 Transm. temp. above alarm limit; 149 Transm. temp. below alarm limit; 150 Sensor
signal disrupted; 159 Internal error in transmitter
Default
None
Related
Path
Setup → Inputs and outputs → Channel 3 - relay → Device alarms
3.4.6.12
Channel 1 alarms
Description
Channel 1 alarms - The output is active when one of the alarm items occurs.
Setting
153 CH1 loop cur. in lower saturation; 154 CH1 loop cur. in upper saturation; 155 CH1 loop
current deviation; 158 CH1 cable break
Default
None
Related
Path
Setup → Inputs and outputs → Channel 3 - relay → Channel 1 alarms
3.4.6.13
Input/output alarms (1)
Description
Selection of alarm items that impact the output. Applicable if Status mode = Alarm item.
Availability of certain settings depends on Hardware and Software configuration.