Siemens SITRANS F - Timestamp at Minimum Value; Reset Peak Values; Process Value 4

Maintenance and diagnostics
4.5 Peak values
FST030
Function Manual, 04/2017, A5E35693328-AA
279
4.5.3.5
Timestamp at minimum value
Description
Displays the timestamp when minimum value was measured.
Related
This parameter is only available if
Process value
is
not
set to Disabled.
Path Maintenance and diagnostics → Peak values → Process value 3 → Minimum value
timestamp
4.5.3.6
Reset peak values
Description
This command is used to reset the logging of the recorded maximum and minimum values
monitored. The drag pointers will be set to the current value.
Setting
Cancel; Ok
Default
Cancel
Related
This parameter is only available if
Process value
is
not
set to Disabled.
Path
Maintenance and diagnostics → Peak values → Process value 3 → Reset logging
4.5.4
Process value 4
4.5.4.1
Process value
Description
Assign the process value to be monitored.
Setting
Disabled; Volume flow; Mass flow; Standard volume flow; Sound velocity; Flow velocity;
LiquIdent; Density; Medium temperature; Pressure; Kinematic viscosity; Sensor tempera-
ture (RTD); Auxiliary temperature (RTD); Totalizer 1; Totalizer 2; Totalizer 3
Default
Disabled
Related
If this parameter is set to any other setting than Disabled, parameters
Maximum value
,
Maximum value timestamp
,
Minimum value
,
Minimum value timestamp
, and
Reset logging
will be available.
Path
Maintenance and diagnostics → Peak values → Process value 4 → Assign process value