Setup
3.4 Inputs and outputs
FST030
196 Function Manual, 04/2017, A5E35693328-AA
Input/output alarms
Description
Selection of alarm items that impact the output. Applicable if Status mode = Alarm item.
For hydrocarbon and gas applications only.
Setting 186 CH3 input current too low; 187 CH3 input current too high; 188 CH3 external failure;
189 CH4 input current too low; 190 CH4 input current too high; 191 CH4 external failure
Setup → Inputs and outputs → Channel 4 - relay → Input/output alarms
Simulation alarms
Description
Selection of alarm items that impact the output. Mainly simulation alarms. Applicable if
Status mode = Alarm item.
Setting
160 Mass flow simulated; 161 Volume flow simulated; 162 Density simulated; 163 Medium
temp. simulated; 166 Std. volume flow simulated; 167 Totalizer 1 simulated; 168 Totalizer
2 simulated; 169 Totalizer 3 simulated; 170 Loop current simulated
Setup → Inputs and outputs → Channel 4 - relay → Simulation alarms
Selection of alarm classes which impact the status output. Each diagnostic event is allocated
to an alarm class. Applicable if Status mode = Alarm class and Status icons = Standard.
Bit 0: Process value alarm (PA)
Bit 1: Process value warning (PW)
Bit 2: Maintenance alarm (MA)
Bit 3: Maintenance warning (MW)
Bit 4: Maintenance required (MR)
Bit 5: Function check (FC)
To Next Page
Loading...
