Maintenance and diagnostics
4.2 Diagnostic events
FST030
Function Manual, 04/2017, A5E35693328-AA
249
Setting
160 Mass flow simulated; 161 Volume flow simulated; 162 Density simulated; 163 Medium
temp. simulated; 167 Totalizer 1 simulated; 168 Totalizer 2 simulated; 169 Totalizer 3
simulated; 170 Loop current simulated
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
,
and/or
is set to Status
output and
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Simulation events
Simulation events (2)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
289 Sound velocity simulated; 290 Flow velocity simulated; 291 Pressure simulated; 292
Kin. viscosity simulated; 293 Aux. temperature simulated; 294 Sensor temperature simu-
lated; 296 CH5 simulated; 297 CH6 simulated; 298 Std. volume flow simulated; 299
Standardizing factor simulated; 300 Std. Kin. viscosity simulated; 301 Std. density simulat-
ed; 302 LiquIdent simulated; 303 API gravity simulated; 304 Std. API gravity simulated;
305 Specific gravity simulated; 306 Std. spec. grav. simulated; 307 Rate of change simu-
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
,
and/or
is set to Status
output and
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Simulation events
Input/output events (1)
Description
If one of the selected events appears this affects the status icon, the related status output
and the alarm on the communication interface.
Setting
214 Channel 2 simulated; 215 Channel 3 simulated; 217 Process values frozen; 218 All
To Next Page
Loading...
