Siemens SITRANS F - Alarm Class; Audit Trail; Parameter Change Log; Clear Parameter Change Log (Write Only)

Maintenance and diagnostics
4.9 Audit trail
FST030
Function Manual, 04/2017, A5E35693328-AA
305
Related
This parameter can only be accessed if
Status icons
is set to Standard.
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarm class
4.8.3.4
Alarm class
Description
The NAMUR alarm class to be simulated can be configured. The alarm status is activiated
on all outputs.
Setting
Failure; Function check; Out of specification; Maintenance required
Default
None selected
Related
This parameter can only be accessed if
Status icons
is set to NAMUR.
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarm class
4.9
Audit trail
4.9.1
Parameter change log
Description
Displays list of logged parameter changes. (Log shows parameter value before the change,
not the current value.)
Path
Maintenance and diagnostics → Audit trail → Parameter change log
4.9.2
Clear parameter change log (write only)
Description
The parameter change log can be reset using this parameter.
Setting
Cancel; Ok
Default
Cancel
Related
Path
Maintenance and diagnostics → Audit trail → Clear parameter change log