Siemens SITRANS F - NAMUR Status Signal; Polarity; On Delay

Setup
3.4 Inputs and outputs
FST030
Function Manual, 04/2017, A5E35693328-AA
197
Setting Maintenance alarm; Function check; Process value alarm; Process value warning; Mainte-
nance demanded; Maintenance required; None
Default
Related
Path
Setup → Inputs and outputs → Channel 4 - relay → Alarm class
3.4.8.15
NAMUR status signal
Description
Selection of NAMUR status signals which impact the status output. Each diagnostic event is
allocated to a NAMUR status signal. Application if Status mode = Alarm class and Status
icons = NAMUR
Setting
Failure; Function check; Out of specification; Maintenance required
Default
None
Related
Path Setup → Inputs and outputs → Channel 4 - relay → NAMUR status signal
3.4.8.16
Polarity
Description
Logical polarity of status output.
Setting
Active high level; Active low level
Default
Active high level
Related
Path
Setup → Inputs and outputs → Channel 4 - relay → Polarity
3.4.8.17
On delay
Description
Sets the time delay between alarm condition and activating the output.
Setting
0.00 s to 100.00 s
Default
0.00 s