Siemens SITRANS F - Page 305

Maintenance and diagnostics
4.8 Simulation
FST030
Function Manual, 04/2017, A5E35693328-AA
303
Related
This parameter is only available if
Simulation mode
is set to Simulate alarm (ID number).
Path Maintenance and diagnostics → Simulation → Simulation alarms → Alarms → Process
alarms (2)
4.8.3.2.5 Process alarms (3)
Description
The simulation of single and multiple
Process alarms (3)
can be configured.
Setting Various process alarms can be selected
Default
None selected
Related
This parameter is only available if
Simulation mode
is set to Simulate alarm (ID number).
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarms → Process
alarms (3)
4.8.3.2.6 Process alarms (4)
Description
The simulation of single and multiple
Process alarms (4)
can be configured.
Setting
Various process alarms can be selected
Default
None selected
Related
This parameter is only available if
Simulation mode
is set to Simulate alarm (ID number).
Path
Maintenance and diagnostics → Simulation → Simulation alarms → Alarms → Process
alarms (4)
4.8.3.2.7 Totalizer alarms
Description
The simulation of single and multiple
Totalizer alarms
can be configured.
Setting
Totalizer 1 above alarm limit; Totalizer 1 above warning limit; Totalizer 1 below warning
limit; Totalizer 1 below alarm limit; Totalizer 2 above alarm limit; Totalizer 2 above warning
limit; Totalizer 2 below warning limit; Totalizer 2 below alarm limit; Totalizer 3 above alarm
limit; Totalizer 3 above warning limit; Totalizer 3 below warning limit; Totalizer 4 below
alarm limit
Default
None selected