P
ORT
C
ONFIGURATION
3-133
Command Usage
• Input and output rate limits can be enabled or disabled for individual
interfaces.
Command Attributes
• Port/Trunk – Displays the port/trunk number.
• Input/Output Rate Limit Status – Enables or disables the rate limit.
(Default: Enabled)
• Input/Output Rate Limit – Sets the rate limit level.
Web – Click Port, Rate Limit, Input/Output Port/Trunk Configuration.
Enable the Rate Limit Status for the required interfaces, set the Rate Limit
Level, and click Apply.
Figure 3-58. Input Rate Limit Port Configuration
CLI - This example sets the rate limit level for input traffic passing
through port 3.
Console(config)#interface ethernet 1/3 4-156
Console(config-if)#rate-limit input 500 4-173
Console(config-if)#
To Next Page
Loading...
Need help?
General
