VLAN C
OMMANDS
4-217
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
GVRP and Bridge Extension Commands
GARP VLAN Registration Protocol defines a way for switches to
exchange VLAN information in order to automatically register VLAN
members on interfaces across the network. This section describes how to
enable GVRP for individual interfaces and globally for the switch, as well
as how to display default configuration settings for the Bridge Extension
MIB.
VLANs
Command Groups Function Pag
e
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for bridge
extension MIB
4-21
7
Editing VLAN
Groups
Sets up VLAN groups, including name, VID and
state
4-22
3
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including
ingress and egress tagging mode, ingress filtering,
PVID, and GVRP
4-22
5
Displaying VLAN
Information
Displays VLAN groups, status, port members, and
MAC addresses
4-23
3
Configuring Private
VLANs
Configures private VLANs, including uplink and
downlink ports
4-23
4
Configuring Protocol
VLANs
Configures protocol-based VLANs based on frame
type and protocol
4-24
3
To Next Page
Loading...
Need help?
General
