SMC Networks TigerSwitch SMC6128PL2 User Manual

4-156
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enter interface
configuration mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface
configuration mode
GC 4-156
description Adds a description to an interface configuration IC 4-157
speed-duplex Configures the speed and duplex operation of a
given interface when autonegotiation is disabled
IC 4-158
negotiation Enables autonegotiation of a given interface IC 4-159
capabilities Advertises the capabilities of a given interface
for use in autonegotiation
IC 4-160
flowcontrol Enables flow control on a given interface IC 4-161
shutdown Disables an interface IC 4-163
switchport
broadcast
packet-rate
Configures the broadcast storm control
threshold
IC 4-164
clear counters Clears statistics on an interface PE 4-164
show interfaces
status
Displays status for the specified interface NE,
PE
4-165
show interfaces
counters
Displays statistics for the specified interfaces NE,
PE
4-166
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
4-168

SMC Networks TigerSwitch SMC6128PL2 Specifications

General

Brand	SMC Networks
Model	TigerSwitch SMC6128PL2
Category	Switch
Language	English