SNMP C
OMMANDS
4-141
snmp-server location
This command sets the system location string. Use the no form to remove
the location string.
Syntax
snmp-server location text
no snmp-server location
text - String that describes the system location.
(Maximum
length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact (4-140)
snmp-server host
This command specifies the recipient of a Simple Network Management
Protocol notification operation. Use the no form to remove the specified
host.
Syntax
snmp-server host host-addr [inform [retry retries | timeout seconds]]
community-string [version {1 | 2c | 3 {auth | noauth | priv}
[udp-port
port]}
no snmp-server host host-addr
-host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
- inform - Notifications are sent as inform messages. Note that this
Console(config)#snmp-server location WC-19
Console(config)#
To Next Page
Loading...
Need help?
General
