SMC Networks TigerSwitch SMC6128PL2

4-266
• You must first define a class map, then define a policy map, and finally
use the service-policy command to bind the policy map to the
required interface.
Example
This example applies a service policy to an ingress interface.
show class-map
This command displays the QoS class maps which define matching criteria
used for classifying traffic.
Syntax
show class-map [ class-map-name ]
class-map-name - Name of the class map. (Range: 1-16 characters)
Default Setting
Displays all class maps.
Command Mode
Privileged Exec
Example
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd_policy
Console(config-if)#
Console#show class-map
Class Map match-any rd_class#1
Match ip dscp 3
Class Map match-any rd_class#2
Match ip precedence 5
Class Map match-any rd_class#3
Match vlan 1
Console#