4-236
5. Use the switchport private-vlan mapping command to assign a port
to a primary VLAN.
6. Use the show vlan private-vlan command to verify your configuration
settings.
To configure isolated VLANs, follow these steps:
1.Use the private-vlan command to designate an isolated VLAN that will
contain a single promiscuous port and one or more isolated ports.
2. Use the switchport mode private-vlan command to configure one
port as promiscuous (i.e., having access to all ports in the isolated
VLAN) one or more ports as host (i.e., isolated port).
3. Use the switchport private-vlan isolated command to assign a port to
an isolated VLAN.
4. Use the show vlan private-vlan command to verify your configuration
settings.
private-vlan
Use this command to create a primary, community, or isolated private
VLAN. Use the no form to remove the specified private VLAN.
Syntax
private-vlan vlan-id {community | primary | isolated}
no private-vlan vlan-id
- vlan-id - ID of private VLAN. (Range: 1-4094, no leading zeroes).
- community - A VLAN in which traffic is restricted to host
members in the same VLAN and to promiscuous ports in the
associate primary VLAN.
- primary - A VLAN which can contain one or more community
VLANs, and serves to channel traffic between community
VLANs and other locations.
- isolated – Specifies an isolated VLAN. Ports assigned to an
isolated VLAN can only communicate with the promiscuous port
within their own VLAN.
To Next Page
Loading...
Need help?
General
