S
IMPLE
N
ETWORK
M
ANAGEMENT
P
ROTOCOL
3-51
CLI – The following example adds the string “spiderman” with read/write
access.
Specifying Trap Managers and Trap Types
Traps indicating status changes are issued by the switch to specified trap
managers. You must specify trap managers so that key events are reported
by this switch to your management station (using network management
platforms such as HP OpenView). You can specify up to five management
stations that will receive authentication failure messages and other trap
messages from the switch.
Command Attributes
• Trap Manager Capability – This switch supports up to five trap
managers.
• Current – Displays a list of the trap managers currently configured.
• Trap Manager IP Address – IP address of the host (the targeted
recipient).
• Trap Manager Community String – Community string sent with the
notification operation. (Range: 1-32 characters, case sensitive)
• Trap UDP Port – Sets the UDP port number. (Default: 162)
• Trap Version – Specifies whether to send notifications as SNMP v1,
v2c, or v3 traps. (The default is version 1.)
• Trap Security Level – Specifies the security level.
• Enable Authentication Traps – Issues a trap message whenever an
invalid community string is submitted during the SNMP access
authentication process. (Default: Enabled)
• Enable Link-up and Link-down Traps – Issues a trap message
whenever a port link is established or broken. (Default: Enabled)
Console(config)#snmp-server community spiderman rw 4-139
Console(config)#
To Next Page
Loading...
Need help?
General
