M
ULTICAST
F
ILTERING
C
OMMANDS
4-279
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (4-271)
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
- vlan-id - VLAN ID (Range: 1-4094)
- interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-52)
• port-channel channel-id (Range: 1-8)
Default Setting
No static multicast router ports are configured.
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan
mrouter
Adds a multicast router port GC 4-279
show ip igmp snooping
mrouter
Shows multicast router ports PE 4-280
To Next Page
Loading...
Need help?
General
