C
OMMAND
L
INE
I
NTERFACE
4-30
In this example, the show history command lists the contents of the
command history buffer:
The ! command repeats commands from the Execution command history
buffer when you are in Normal Exec or Privileged Exec Mode, and
commands from the Configuration command history buffer when you are
in any of the configuration modes. In this example, the !2 command
repeats the second command in the Execution history buffer (config).
reload
This command restarts the system.
Note: When the system is restarted, it will always run the Power-On
Self-Test. It will also retain all configuration information stored in
non-volatile memory by the copy running-config startup-config
command.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command resets the entire system.
Console#show history
Execution command history:
2 config
1 show history
Configuration command history:
4 interface vlan 1
3 exit
2 interface vlan 1
1 end
Console#
Console#!2
Console#config
Console(config)#
To Next Page
Loading...
Need help?
General
