C
ONFIGURING
THE
S
WITCH
3-240
Figure 3-104. MVR Global Configuration
CLI – This example first enables IGMP snooping, enables MVR globally,
and then configures a range of MVR group addresses.
Displaying MVR Interface Status
You can display information about the interfaces attached to the MVR
VLAN.
Field Attributes
• Type – Shows the MVR port type.
• Oper Status – Shows the link status.
• MVR Status – Shows the MVR status. MVR status for source ports is
“ACTIVE” if MVR is globally enabled on the switch. MVR status for
receiver ports is “ACTIVE” only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
Console(config)#ip igmp snooping 4-270
Console(config)#mvr 4-283
Console(config)#mvr group 228.1.23.1 10 4-283
Console(config)#
To Next Page
Loading...
