4-158
The following example adds a description to port 24.
speed-duplex
This command configures the speed and duplex mode of a given interface
when autonegotiation is disabled. Use the no form to restore the default.
Syntax
speed-duplex {1000full | 100full | 100half | 10full | 10half}
no speed-duplex
- 1000full - Forces 1000 Mbps full-duplex operation
- 100full - Forces 100 Mbps full-duplex operation
- 100half - Forces 100 Mbps half-duplex operation
- 10full - Forces 10 Mbps full-duplex operation
- 10half - Forces 10 Mbps half-duplex operation
Console(config)#interface ethernet 1/24
Console(config-if)#description RD-SW#3
Console(config-if)#
To Next Page
Loading...
Need help?
General
