I
NTRODUCTION
1-8
System Defaults
The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file
should be set as the startup configuration file (page 3-27).
The following table lists some of the basic system defaults.
Table 1-2. System Defaults
Function Parameter Default
Console Port
Connection
Baud Rate 9600
Data bits 8
Stop bits 1
Parity none
Local Console Timeout 0 (disabled)
Authentication Privileged Exec Level Username “admin”
Password “admin”
Normal Exec Level Username “guest”
Password “guest”
Enable Privileged Exec
from Normal Exec Level
Password “super”
RADIUS Authentication Disabled
TACACS Authentication Disabled
802.1X Port
Authentication
Disabled
HTTPS Enabled
SSH Disabled
Port Security Disabled
IP Filtering Disabled
To Next Page
Loading...
Need help?
General
